Harman Stove Company PB 105 Manuel d'utilisateur télécharger pdf (Page 27)

4. If Starting After an Empty Hopper, Turn Feed

Adjuster to “TEST” (for one 60 second cycle).

This will feed pellets into the auger tube and also

allow you to check the motors for operation. NOTE:

The auger motor will not operate with any of the

doors open.

5. Turn Feed Adjuster to #4.

If this is your rst re or you are trying differ-

ent pellets, set the feed adjuster to #4, This is an

average number for most pellets and may need to

be adjusted for your particular fuel. After you know

a feed rate setting that works well for your applica-

tion, use that setting.

NOTE: You know your feed rate is too high when:

The overheat safety feature is energized each time

the heating zone demand turns off during a high burn.

OR, If unburned or partially burned pellets are found

in the ash pan.(this may also be an indication of a

burn pot in need of scraping.)

7. Turn the MAX. TEMP. Dial on the control

board to the desired temperature. This setting must

always be at least 5° F. higher than the MIN. TEMP.

setting.



6. Flip the Igniter Switch up into the “AUTO”

position.

WARNING: HOT WHILE IN OPERATION.

KE E P CH I LDR E N, CL OTH I NG, A N D

FURNITURE AWAY. CONTACT MAY CAUSE

SKIN BURNS.

WATER TEMPERATURE

MAX. TEMP.

MIN. TEMP.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Pas de commentaire

Harman Stove Company PB 105 Manuel d'utilisateur Page 27