Harman Stove Company PB 105 Manuel d'utilisateur télécharger pdf (Page 26)

1. Turn Mode Selector to “OFF”.

This resets the control in addition to turning

it off.

Starting A Fire Automatically



2. Clean Burnpot with scraper, if necessary.

This is usually a weekly maintenance proce-

dure. Cleaning the burn pot with the scraper with

a small amount of new fuel in the bottom is not a

problem. First, scrape the ashes on the front of the

burn pot into the ash pan. Then scrape the hole grid

surface downward into the burn pot. When the stove

is ignited these scrapings will be pushed out by the

feeder.

The illustration at left shows the hopper swing plate

open for easy access to the burn pot. The burn pot

can also be reached through the rebox door.

NOTE: To minimize the amount of stress placed

on the hopper swing plate hinges, opening of the

hopper swing plate should be done with the least

amount of fuel in the hopper as possible.

3. Fill Hopper with pellets.

When lling the hopper check for excessive nes

in the bottom of the hopper. Fines are small pieces of

broken pellets (sawdust). Fines do not ow easily and

often build up on the hopper funnel bottom angles.

These nes can be pushed into the feeder opening

and then ll the hopper with pellets. As the system

works, they will be burned.

Ash Pan

Ash Pan Handle

Scrape burnpot to remove any carbon

build-up that may have occurred

Scraping can be done while in operation

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 47 48

Pas de commentaire

Harman Stove Company PB 105 Manuel d'utilisateur Page 26