Harman-stove-company XL Manuel d'utilisateur

ShadowLight XLDirect Vent Gas Fireplace InsertOwners ManualWARNING: If the information in this manual is not followed exactly, a fire or explosion may

Operation15. Set the High-Low Regulator to desired setting: Turn fully counterclockwise for High and fully clockwise for Low.NOTE: An odor, result

InstallationOnly For Qualified InstallersPacking ListInside the Insert BoxShadowLight XL InsertLog setBag of rock woolOwners ManualRestrictor PlatesIns

InstallationOnly For Qualified InstallersInstallationDue to high temperatures, the ShadowLight XL Fireplace Insert should be located out of traffic and

InstallationOnly For Qualified InstallersMaking The ConnectionThe gas inlet is located on the bottom right side of the fireplace. The inlet fitting is 1/

InstallationOnly For Qualified InstallersNatural Gas Kit Part No. 1-00-00384LP Kit Part No. 1-00-00385Conversion labelPilot Orifice Main Orifice #31

InstallationOnly For Qualified InstallersDoor LatchesRemove door by pulling latches out as shown and pulling the bottom of the door out from th

InstallationOnly For Qualified InstallersRemove three screws to change knob assembly. Install NG knob assembly in place of the LP assembly. Be sure scr

Specifications Door LatchesRemove door by pulling latches out as shown and pulling the bottom of the door out from the unit about 3”. Then lift

InstallationOnly For Qualified InstallersPreliminary steps to prepare for the installation of the ShadowLight XL Fireplace InsertRemove the chimney cap

InstallationOnly For Qualified InstallersUse Only Approved VentingThis appliance has been tested and is listed for installation with Simpson Duravent G

Manufactured by:Harman Stove Co.352 Mountain House RoadHalifax, PA 17032WARNING: If the information in this manual is not followed exactly,

InstallationOnly For Qualified InstallersRemove the screw, washer and spacer from the center of the rear brick panel. Using one hand, gently pu

InstallationOnly For Qualified Installers5Using a 1/2” deep well socket loosen the nut that was under the exhaust cover plate until it is flush with the

InstallationOnly For Qualified InstallersConnect the gas pipe to the stove unit. If the pipe adapter was removed from the stove, replace all components

InstallationOnly For Qualified InstallersInstall the face doors by hanging them on the hinges. Note: a brass washer goes between the hinges. The finishe

InstallationOnly For Qualified InstallersConnecting the Optional Thermostat If the optional thermostat is used, it must be plugged into the terminal s

MaintenanceRemoving the Glass DoorRemove door by pulling latches out as shown and pulling the bottom of the door out from the unit about 3 inches. The

MaintenanceAir InAir OutThe flow of convection air must not be obstructed. Cleaning the BurnersTo clean the burners, the face, glass front, and log set

MAGENTAMAGENTAMAGENTAMAGENTAWiring DiagramsHigh Voltage DIagramLow Voltage DIagramBlowerPower CordVariable Speed SwitchBlower SwitchExternal Thermosta

Shadowlight XL Parts281. Face Assembly 1-00-3842002. Glass Door Assembly 1-10-3841483. Glass 3-40-185029004. Label Bracket Assy. 1-10-3841365a

Burner Module Parts2916. Body Weldment 1-89-38430017. Flue Access Cover 2-00-38430718. AIr Plate Assembly 1-10-38430719. Low Voltage Ha

INTRODUCTION ... 4SPECIFICATIONS ... 5O

Trouble ShootingManifold Pressure 10 inches (High-Low Regulator turned fully counter-clockwise.)Inlet Pressure 11 to 13 inchesManifold Pressure 3.5 i

Trouble ShootingLook to see if a spark jumps from the ignitor electrode to the pilot when the ignitor button is pushed.Check igniter wire and connecti

Trouble ShootingGoodGoodCheck Milivolt output of thermocouple. Should be 10 or more MV.Check inlet pressureBadAdjust pilot adjustment to achieve prope

Trouble ShootingMain Burner will not light (with valve in “on” position)Is Pilot litnoLight pilotYesCheck Thermopile voltage at terminals marked TP on

Harman Stove Company warrants its products to be free from defects in material or workmanship, in normal use and service, for a period of 6 years from

The installation of the ShadowLight XL Fireplace Insert must conform with local codes, or in the absence of local codes, with National Fuel Gas Code,

Specifications 40”30”Front ViewMinimum Opening Size: 29” InletOutletTop ViewSide ViewFront View14”13”5

Specifications Hi-Low KnobOn-Off-Pilot KnobIgniterBlower Speed SwitchOn-Off- Thermostat SwitchPilotGlass DoorLatch HandleLeveling BoltLeveling BoltBurn

Specifications Leveling BoltVentAir IntakeOn-Off Thermostat SwitchOn-OffThermostat Switch Connector RATINGS NATURAL PR

OperationPILOTDoor HandlesWarningDoors Are Hot While In Operation. Wear Gloves and Only Touch Doors On The Handles.Lift bottom grill with index finger

OperationOperationHOW TO LIGHT THE FIRE1. STOP! Read the safety information on the front cover.2. If using the optional thermostat, set